Completed Jobs by Bock Air Conditioning

April 29, 2026 | Crowley, 76036

We went out there and found that the indoor primary drain was clogged. Technician vacuumed and flushed the lines. Everything is back to cooling and draining properly.

April 28, 2026 | Joshua, TX

The customer contacted us stating their thermostat was set to 72°F, but the indoor temperature had increased to 78°F and continued rising. We found a bad run capacitor at the condenser and debris covering it. The indoor coil was clean. We replaced the capacitor, changed the filter, and washed the ...

April 28, 2026 | River Oaks, TX

We inspected the system and found the refrigerant level was low and the capacitor was weak. We added refrigerant to bring levels back within range. The system is now operating properly.

April 27, 2026 | Burleson, TX

Our technician inspected the system and discovered the float switch had been triggered by a clogged drain line. After clearing the blockage and readjusting the float switch, the system was restored to proper working condition and is now running normally.

April 27, 2026 | Euless, TX

We checked the system and found no clogs. The suction line insulation was loose, so we re-taped and strapped it back on. Everything is now working properly and no more water is dripping.

April 24, 2026 | Alvarado, TX

The customer called and requested that we come out and reseal all her ducts due to cats getting under her home and tearing them apart. Our team repaired the 12" crossover supply duct and properly resealed all connections to restore optimal airflow. Refrigerant levels were checked and found to be good. ...

April 24, 2026 | Granbury, TX

We inspected the system and found a heavily clogged P-trap with significant buildup, which was affecting drainage. The float switch was improperly positioned and triggering the outdoor defrost board. We corrected the float switch, cleaned the P-trap, washed the outdoor condenser, and cleared the drain lines. The system is now ...

April 15, 2026 | Weatherford, TX

Technician responded to service call and found multiple ants inside the 1.5-pole contactor, causing improper operation. The contactor was replaced, and system operation was tested. Equipment is now running properly.

April 15, 2026 | Fort Worth, TX

Upon inspection, our technician found that the system was overcharged with refrigerant. Charge was corrected to proper levels. Technician also cleaned the outdoor unit and opened several supply vents to improve airflow. System was tested and is now operating properly.

April 14, 2026 | Haltom City, TX

Technician responded to the golf room not cooling. Upon inspection, found that the air filter was dirty and the breaker had tripped. Technician replaced/cleaned the filter and reset the breaker, restoring proper operation. While on site, technician also checked two additional systems to ensure they were operating efficiently. All ...

April 14, 2026 | Burleson, TX

One of our technicians went out there and found that the evaporator coil was leaking. We pulled vacuum, replaced inside coil, and added around 3 pounds of freon. Everything is cooling and working great/

April 13, 2026 | Burleson, TX

We sent one of our technicians out there to complete the maintenance. Everything was running properly and cooling great!

April 13, 2026 | Cleburne, TX

Technician performed a full system inspection. Upon arrival, both the air conditioning and heating systems were operating properly. Filters were clean, and all system levels were within normal range. No issues found at this time.

April 13, 2026 | Granbury, TX

Upon our technician arriving we found the upstairs unit was short cycling and was locking out. Reset the system and everything is working good. The mini split was not working because there was no freon in the system. We preformed an advanced leak search and we found no leak. Added ...

April 10, 2026 | Burleson, TX

We went there and found that the system needed to be replaced. It was in bad shape and 18 years old. Next day we went out and installed a new condenser and air handler. Everything is up and running great and cooling like needed!