Completed Jobs by Bock Air Conditioning

July 23, 2026 | Arlington, TX

Customer contacted us for an estimate on a new HVAC system. After reviewing their home's needs, we provided a quote for a new Goodman 14 SEER gas system. The customer chose to move forward with the installation, and we installed a new furnace, evaporator coil, outdoor condenser, and thermostat. The new ...

July 21, 2026 | Burleson, TX

As part of our maintenance agreement program, we contacted the customer to schedule their routine service. During the inspection, we found the system was low on refrigerant due to a leak in the evaporator coil. The indoor unit also needs to be cleaned. All other components were operating properly at ...

July 20, 2026 | Arlington, TX

The customer called because their system was not cooling. We found the outdoor control board had proper voltage but failed to power on, preventing communication with the indoor unit and thermostat. We restored the system to normal operation and grounded the compressor windings. We recommended replacing the control board if ...

July 20, 2026 | Burleson, TX

The customer called because their home was not cooling. We found the outdoor unit had a failed capacitor and replaced it. After testing the system, everything was operating and cooling properly.

July 20, 2026 | Lakeside, TX

We scheduled the customer's A/C maintenance as part of her membership. During the visit, she renewed her Level 2 maintenance agreement, and we installed a soft start kit to help reduce compressor startup stress and prevent premature failure.

July 20, 2026 | Burleson, TX

Customer is enrolled in our maintenance agreement, so we performed their scheduled A/C maintenance. We completed a full system inspection, and everything is operating properly and cooling well.

July 16, 2026 | Fort Worth, TX

Customer's drain pan had cracked and needed to be replaced. We installed a new drain pan, cleaned both the indoor evaporator coil and the outdoor condenser coil, and tested the system. Everything is now operating properly and draining as it should.

July 14, 2026 | Midlothian, TX

We contacted the customer to perform their routine maintenance as part of their maintenance agreement. Both the upstairs and downstairs systems were operating properly. We found high startup amp draw on the outdoor compressors, so we installed two soft start kits to reduce startup amps and replaced a capacitor as ...

July 13, 2026 | Mansfield, TX

The customer called because their system was making a loud noise during the night. We found the blower motor had failed, damaging the blower wheel and housing. We replaced the blower motor and blower wheel assembly, and the system is now operating properly.

July 11, 2026 | Fort Worth, TX

The customer called because the thermostat showed the temperature was rising. We found the condensate drain line was clogged, causing the safety switch to shut the system off. We cleared the drain line and P-trap, and the system is now running and cooling properly.

July 10, 2026 | Grand Prairie, TX

As part of our maintenance agreement program, we contacted the customer to schedule their routine maintenance. During the inspection, we found the system was low on refrigerant. We added the necessary refrigerant, and the system is now operating and cooling properly. All other components were working as expected.

July 10, 2026 | Alvarado, TX

The customer contacted us for a quote on a new mini-split system because their current unit was no longer cooling properly. We found the outdoor unit had a failed control board and compressor. The customer chose to move forward with the replacement, and we installed the new mini-split system along ...

July 10, 2026 | Fort Worth, TX

The customer called because their system was making a noise. We found the outdoor unit had a weak capacitor and replaced it. We also found the compressor has a high amp draw and would benefit from a start assist to help prevent future system failure. After replacing the capacitor, the ...

July 10, 2026 | Burleson, TX

Customer called because the A/C was making a loud noise. We replaced the outdoor contactor, capacitor, cleaned the condenser coil, and installed a soft start kit to reduce compressor startup amperage. System is now operating properly.

July 10, 2026 | Arlington, TX

We reached out to the customer to schedule their routine maintenance. During our 25-point inspection, we found the system to be in good condition and operating properly. Everything checked out well, and the system is running efficiently.